Yacht Dock 10 x 6 ft Inflatable Boat Dock Swim Platform

The Island Hopper Yacht Dock 10 x 6 ft is the most versatile inflatable boat dock in the lineup and, according to the owner of Island Hopper, the favorite size in the entire platform range. At 10 feet long and 6 feet wide, this 60-square-foot inflatable dock is just enough platform for the whole family, stable enough that an adult sitting on one corner is not bothered by kids jumping off the other side, and narrow enough that you can inflate it in 8 minutes off the back of a boat, on a beach, on a dock, or anywhere you have flat ground and 6 feet of width. Commercial-grade heat-welded drop-stitch PVC, rubber corner bumpers, suction cup stability, and a single white fold mark down the center for quick storage make this the most universal island, dock, and boat extension Island Hopper makes.

60 SQUARE FEET | 1,500 LB CAPACITY | THE WHOLE FAMILY FITS

The Yacht Dock 10 x 6 ft delivers 60 square feet of rigid, non-slip inflatable dock surface with a 1,500-pound weight capacity. That is enough capacity and space for a full family to spread out comfortably on the water without anyone crowding anyone else. Adults can lounge on one half. Kids can jump from the other. The platform does not move enough to notice.

SUCTION CUP STABILITY | RUBBER CORNER BUMPERS | 1 ENTRY AREA

All the Island Hopper Inflatable Docks stay stable by suctioning down to the water due to the sq/ft of inflatable touching the water. The Yacht Dock size allows it to suction down toward the water surface, dramatically increasing stability at rest and under load. This is what makes it possible to have an adult sitting calmly on one corner while kids are jumping on the other side. The platform stays planted rather than rocking with the motion. Rubber protective bumpers on all four corners absorb impact from the boat hull, dock posts, and shoreline surfaces, protecting the platform and anything it touches. A single dedicated entry area with grip handles makes it easy to board. An optional soft rope ladder can be purchased separately. 

INFLATES ANYWHERE IN 8 MINUTES | BEACH | BACK OF A BOAT | DOCK

The 6-foot beam width of the Yacht Dock is the number that makes it truly universal. Six feet is narrow enough to roll out and inflate on a beach, on a dock, or off the stern of almost any boat; including smaller vessels where a 10-foot platform would be impossible to deploy of the back. Inflate in 8 minutes with the included double-action hand pump. Set it in the water, clip the boarding line, and you have a floating dock wherever you are. For faster inflation, the separately available PSI 15 Auto-Set Electric Inflator stops automatically at the correct pressure and cuts setup time significantly. No fixed location required. No trailer. No installation. Inflate it where you need it, deflate it when you are done.

FOLD DOWN THE MIDDLE | STORES IN 10 MINUTES | 40 x 16 x 14 PACKED

This inflatable floating dock folds down with a single white fold mark running down the center of the platform. Deflate, fold on the white line, roll from one end, strap with the included carry straps, and you are done in approximately 10 minutes. Packed dimensions are 40 x 16 x 14 inches and 53 pounds. Lighter and more compact than the Patio Dock or the Mega Yacht Dock. It fits in a gear bag in the trunk, the cockpit of a boat, or a locker on a larger vessel. 

EXTENDS ANY BOAT'S SWIM DECK | THE MOST UNIVERSAL DOCK ON THE WATER

The Yacht Dock 10 x 6 ft was designed to extend any boat's swim deck and go away the moment you do not need it. Clip it to the stern, the side, or a dock cleat and it works as a swim platform extension on a pontoon boat, a boarding platform off a yacht, a lounge dock at a mooring ball, or a standalone floating island at the swim hole. It is the inflatable dock that fits every water situation.

COMMERCIAL-GRADE DROP-STITCH PVC | HEAT-WELDED SEAMS | UV RESISTANT

The Yacht Dock 10 x 6 ft is built from the same commercial-grade materials as the rest of the Island Hopper platform lineup: drop-stitch PVC core inflated to 8-15 PSI for a rigid, non-flex surface; reinforced 1000-denier rip-resistant outer fabric that handles UV exposure, oil stains, and surface abrasion across multiple seasons; and heat-welded seams throughout that eliminate the slow-leak failure mode of adhesive-bonded recreational inflatables. This is a platform built to be used, not babied. Inflate it, load it, leave it, and come back next weekend knowing it will be exactly as you left it.

Weight:

53 lbs

Inflated Dimensions:

10 ft x 6 ft x 6 in

Weight Capacity:

1500 lbs

Rolled-up Dimensions:

40 x 16 x 14 in

Box Dimensions:

36 x 24 x 15 in

Heat-welded PVC with reinforced 1000-denier rip-resistant fabric layer for heavy-duty use; UV- and oil-stain-resistant. No glued edges or corners. Stainless steel side D-rings. Rubber bumpers on corners.

• Double action hand pump
• storage and carry straps
• Owners manual
• Repair Patches

Click the link to contact us for more information on product.

Unopened items can be returned within 10 days for a full refund; used products require prior written consent and may incur a 20 % restocking fee. All products must be registered within 30 days to qualify for the warranty. Learn more.

Inflatable Repair Process Video

Inflating Island Hopper Product Video